PipeCaster Pro pipe
IPP Solutions' PipeCaster Pro at workLining vertical runs
Resources
Apex CIPP Solutions & Dancutter USA
4545 Samuel Street
Sarasota, FL 34233
Tel. 941-300-0441
E-mail: craig@apexcipp.com
PrimeLine Products, Inc.
311 Altamonte Commerce Blvd., Suite 1608
Altamonte Springs, FL 32714
Tel. 407-772-8131
E-mail: nate@primelineproducts.com
Jetter Depot
6385 Cross Roads Rd.,
Cumming, GA 30041
Tel. 866-553-8837
E-mail: andrew@jetterdepot.com
EPL Solutions, Inc.
1330 W. Collins Avenue,
Orange, CA 92867
Tel 714-453-9760
E-mail: john@epls-usa.com
IPP Solutions Canada, Inc.
30-800 Route Carter,
Sainte-Marie, QC G6E 0B2
Canada
Tel. 418-809-9309
E-mail: simon@ippsolutionscanada.com
IPP Solutions
ResourcesAre you interested in becoming an official distributor for PipeCaster Pro? If you answered yes, fantastic! Just contact us and we will provide you with all of the information you need to get started. This includes product, pricing as well as merchandising details that can help you become the best distributor you can be.
VideosBlog & Articles
September 23, 2025
September 23, 2025
September 23, 2025Commercial pipe rehabilitation is no easy undertaking. Contractors want
Do you want to see how PipeCaster Pro works? We offer live demonstrations. Just fill out the form below with your information and we will get back to you to set up a time.
Get In Touch With Us
5192 Bolsa Ave, Suite 5 Huntington Beach, CA 92649
Book an appointmentResources
Standard is 100ft. and can be extended up to 400ft. for our PCP Pro model.
NO, hoses are reusable.
Yes, all material may be recycled back into storage containers after the job is completed. ♻️
The smallest is 2” however it does depend on the condition of the pipe (interior build-up, etc.) We do recommend brush coating for this size which can go down to 1.25”.
Also, spray head is 1.25” diameter and thus will make multiple coats a bit more challenging.
Raw material must be stored in a dry area and completely sealed.
PCP Micro can be managed with 1 technician, all other units should have 2 technicians at a minimum.
With tanks it’s approximately 160lbs.
Without tanks it’s approximately 120lbs.
Generally NO, as it is low viscosity, however in very low temps we do recommend heating first.
Cast iron, PVC, Metal, concrete, clay, terracotta, wood, steel.
Potable water pipes, yes, some our materials are NSF61 Chapter 5 approved.
Yes, though there is a special procedure:
cleaning, prepping, and priming, and coating.
Yes, we have specialized ULFM approved materials but it must be approved by local Fire Marshal first.
Yes, we’ve had several contractors who’s done so, especially under concrete slabs.
Yes, all pipes above 3” can be done with spray coating and anything under 3” must be brush coated.
NO, water must be removed.
You can use an industrial shop vac. and you can extend the vac. hose by using a pool hose. You can also wrap towels or sponges around pushrod camera and let the material soak up the water.
Pipe must be free of rust, debris, oil, and other contaminants.
Descaling and/or jetting machine, which are part of the package.
Pipe must be moisture-free.
Using air blower/dryer which is part of the package.
Most common issue is when the system is not cleaned properly causing the material to harden and or gum-up the in machine, requiring you to repair/replace certain parts.